Tips Trik Pemakaian ( User guide )
1. Do not put e-cigarette in the position of the LED light is below, could result in fluid from the cartridge down to the bottom, can result in short circuit batteries. (Remember, this is made of electronic distinguished enough sensitivity HIGH).
2. SUGGESTED does not suck TOO STRONG, VERY GENTLE HISAPLAH with, because it will result in powerful suction fluid out of the hole the cartridge (making fast fluid runs out), also resulted in rapid heat and potensif Atomizer against permanent damage.
3. Never smoked again when the steam that comes out is the less, this can potentially damage the atomizer because tomizer damaged if inhaled without any liquid / liquid in the cartridge.
4. Give some time when the lag time suck, so Atomizer does not become too hot (too hot will cause Atomizer damaged), and allow about 5-10 seconds each suction for liquid / liquid seep into the pori2 dpt Atomizer.
5. Do not let the battery is empty in a long time.
6. When the smoke remained low with a full cartridge, it needs to be cleaned Atomizer
7. Little steam can be factors as Low Batt, and the batteries must return dicas.
How to Clean Atomizer
(Burner)
1. If not used in quite a long reply (you rest / sleep), then make atomizer and batteries separately. This can make your atomizer and batteries last longer. Fluid absorption against the Atomizer by using Tissue for atomizer always dry juncture.
2. Blow Atomizer with strong winds and clean, for example by a blower / hair dryer (keep your atomizer with hairdryer between 20-25 cm)
3. Soak the tip of atomizer (Atomizer feet) into 70% alcohol for 45 minutes. Atomizer or drying in the sun, but also not too hot (It is recommended not exposed to direct sunlight, because to keep the rubber valve imaginable in Atomizer remain in good condition).
4. When you have a tool that vibrates like a massage tool (or paste dynamo mobil2an pd stainless steel container for producing vibration that serves to shed dirt pd pori2 Atomizer), dipped in alcohol on the stainless steel container for 30 minutes. For materials that clog the pores of the Atomizer can be separated is caused by vibration massage tool / dynamo tsb.
5. Dry your Atomizer with Tissue until all liquid is absorbed by tissue. After Atomizer dry, it can be reused.
Battery Charge
(Charging)
1. Battery indicator FULL / FULL-charge at the time in which there are LED lights on the tip of the cigarette lights up then the mark has not been a full battery. If the light at the end of cigarette is dead, a sign the battery is full / full), and immediately revoked!
2. RECOMMENDED for in-charge via the USB cable to the computer / laptop, because the electric current on the computer / laptop VERY GOOD USED. (An electric current in the Computer / Laptop approaching stable)
3. Do not leave the battery plugged into an electrical current / in-charge for too long.
2. SUGGESTED does not suck TOO STRONG, VERY GENTLE HISAPLAH with, because it will result in powerful suction fluid out of the hole the cartridge (making fast fluid runs out), also resulted in rapid heat and potensif Atomizer against permanent damage.
3. Never smoked again when the steam that comes out is the less, this can potentially damage the atomizer because tomizer damaged if inhaled without any liquid / liquid in the cartridge.
4. Give some time when the lag time suck, so Atomizer does not become too hot (too hot will cause Atomizer damaged), and allow about 5-10 seconds each suction for liquid / liquid seep into the pori2 dpt Atomizer.
5. Do not let the battery is empty in a long time.
6. When the smoke remained low with a full cartridge, it needs to be cleaned Atomizer
7. Little steam can be factors as Low Batt, and the batteries must return dicas.
How to Clean Atomizer
(Burner)
1. If not used in quite a long reply (you rest / sleep), then make atomizer and batteries separately. This can make your atomizer and batteries last longer. Fluid absorption against the Atomizer by using Tissue for atomizer always dry juncture.
2. Blow Atomizer with strong winds and clean, for example by a blower / hair dryer (keep your atomizer with hairdryer between 20-25 cm)
3. Soak the tip of atomizer (Atomizer feet) into 70% alcohol for 45 minutes. Atomizer or drying in the sun, but also not too hot (It is recommended not exposed to direct sunlight, because to keep the rubber valve imaginable in Atomizer remain in good condition).
4. When you have a tool that vibrates like a massage tool (or paste dynamo mobil2an pd stainless steel container for producing vibration that serves to shed dirt pd pori2 Atomizer), dipped in alcohol on the stainless steel container for 30 minutes. For materials that clog the pores of the Atomizer can be separated is caused by vibration massage tool / dynamo tsb.
5. Dry your Atomizer with Tissue until all liquid is absorbed by tissue. After Atomizer dry, it can be reused.
Battery Charge
(Charging)
1. Battery indicator FULL / FULL-charge at the time in which there are LED lights on the tip of the cigarette lights up then the mark has not been a full battery. If the light at the end of cigarette is dead, a sign the battery is full / full), and immediately revoked!
2. RECOMMENDED for in-charge via the USB cable to the computer / laptop, because the electric current on the computer / laptop VERY GOOD USED. (An electric current in the Computer / Laptop approaching stable)
3. Do not leave the battery plugged into an electrical current / in-charge for too long.
Komentar
Posting Komentar